Chart of generation of computer8/28/2023 It is possible to use constrained parameterization techniques to reduce cross-cut discontinuities as discussed in Section 6. Since cuts introduce discontinuities into the parameterization, a delicate balance between the conflicting goals of small distortion and short cuts has to be achieved. To allow parameterizations with low distortion, the surfaces must be cut to reduce the complexity. As previously noted, greater surface complexity usually increases parameterization distortion, independent of the parameterization technique used. ![]() ![]() Hence, closed surfaces and surfaces with genus greater than zero have to be cut prior to planar parameterization. ![]() Planar parameterization is only applicable to surfaces with disk topology.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |